How to use the vacuum pump to increase a member?Instructions

Vacuum pump to increase a member

The use of a special vacuum pump helps not only enhance the erection, but also to increase penis size, as well as achieve greater intimate contact.The principle of operation of this appliance is the difference in dug pressure in the pump-to-pump air, the penis increases in the volume and takes an upright state.

In addition, regular vacuum pump training is treated by the pelvic organs, enhancing blood circulation and saturated tissues with oxygen, vitamins and trace elements.Of course, in order to achieve all these results, it is necessary to use the pump correctly.We will tell you how to use the vacuum procession in this article.

The pump mechanism

The design of the vacuum pump is a cylindrical bottle and a pump, with which the air is pumped from this bottle.In this, the genitals are placed during the process.Due to the results created by air and gas using the device, the result is achieved to increase penis parameters.

Increase a member of the procession

The procedure is as follows:

  1. During air pumping, the pressure is reduced by the bottle.
  2. Blood circulation increases severely, blood is actively rushing to the tissues of the penis.
  3. During negative pressure, blood flow is strengthened.
  4. The caves, of which the Fallos tissue consist of, are filled with blood.
  5. Penis blood vessels increase - both in length and in volume.

This vacuum pump training allows, with the regularity of their application, adds up to 4 cm in one month, and perimeter - up to one and a half.It is necessary to use a vacuum pump for this daily 2-3 times a day, reaching 20 minutes.

How to use it correctly

The milking that the procession with a procession are of high quality and effectively, is necessary to dominate the correct technique.Errors when pumping penis can cause injuries - a gap of blood vessels, hematoma and edema.Beginners are particularly recommended to pay attention to the rules for using a vacuum pump.

Increase a penis using a vacuum pump

The general rules and recommendations in the absence of the genitals body include the following points:

  • Follow the hygiene of the genitals before and after the procedure.
  • Also before and after using the pump, clean the penis and pump using warm water and soap.
  • Before the procedure, run a heated penis with a towel immersed in warm water or bath/shower.
  • The initial use of the pump should be short - about 5 minutes.
  • Then time must be increased gradually, reaching 15-20 minutes at the end.
  • The increase after one use will take about 2 hours.
  • An erection after pumping will remain for 30 minutes - one hour.

The use of a vacuum pump is effective for a rapid increase in a member before sexual intercourse.

In general, all types of devices are effective, however, the rules of use may vary depending on the type of device.

During the use of the pump, it is necessary to monitor the genital skin and their general condition.In the case of infectious and inflammatory processes in this area, you will need to refuse to use the pump.

Aircraft

Having prepared for use using hygiene and heating, carefully study the instructions.Proper use of the device and technology compliance will avoid injury and make the process safe.

The use scheme is as follows:

  • The vacuum cylinder should be pressed tightly at the base of the penis cylinder.If an erection ring is attached to the kit, place it, pressing it on the pubis.
  • Gradually begin to draw air with a pear.The movement should not be very intense.
  • Continue the first lesson for 5 minutes.Over time and experience, increasing it to 10.
  • In case of pain, stop using.
  • It is necessary between the approaches to take 30-60 seconds breaks.At the moment, it is recommended to perform a massage familiar.
  • Over a process, it is recommended to perform 5 sinking approaches.

When using a simple pump with a manual mechanism, it should act independently.The electric version will perform tasks for you.The traction level can be monitored using constructed sensors.The main thing is not to try to increase penis size as soon as possible.Increasing tissues is a complex biological process and must occur at a corresponding rate.

Fork

Water pumps are considered easier to use.This type of device allows you to have a mild effect while remaining effective.The principle of hydraulic operation is similar to the previous option.

Pomping is executed as follows:

  1. Run the preliminary penis heating.
  2. Fill the bottle of the device with warm water and head down.
  3. Then place the device by moving from bottom to top and press it on the base of the penis.
  4. It is then necessary to give the procession with a horizontal position and begin to enhance the pressure.
  5. The air should then be pumped and drained.

In a process, it is recommended to perform 5 pumping approaches in 20 minutes.Make sure that before the penis is extracted from the bottle, the pressure is leveled.Otherwise, you run the risk of getting microchabs and other injuries.

Methods to fly a member

There are many different techniques for using a vacuum pump.The general process for all this is the preliminary heating of the genitals: this is possible with the help of a towel sinking in hot water, as well as the adoption of a hot bath or shower.Make sure the water is not very hot.

In addition, before any type of pumping, it is recommended to perform heating with your hands - they may be both intimate massage techniques and stretching, etc.

Packing

Electrically

This pump use technique is designed to have a maximum effect on the penis.Is intended to a greater extent for penis elongation.In this case, the genitals must be placed in a slightly larger bottle than the phallus itself.

The package is performed in this way:

  • As a preparation, it is necessary to achieve an erection level of 80%.
  • Then it's worth using the lubricant and press the cylinder tightly on the pubis.
  • Check that the slip process is smooth.
  • Set the minimum load and follow the sensors by marking your feelings.This is useful for further determining the necessary load.

First, do not put the tension to the maximum and do not completely stretch the member - this can be done by removing the air from the cylinder not completely.The first set must take 10 minutes.During the execution of the second set, increase the pressure and extend the time to 15 minutes.In the third - enhance the volume and run the pumping for 20 minutes.

Among these approaches it is necessary to take 5 minutes for breaks.Before each subsequent approach, the level of erection must be increased to 90 %.You have to train this way within a week.In the second week, pumping loads are increasing.The maximum pumping time is 25 minutes.

Pomping Classic Member Technique

The classic method of using a vacuum pump to increase the penis in both parameters includes two main techniques:

  • Stretching the protein membrane.
  • Increase the cavernous bodies of the penis.

The systems of their execution are slightly different.

Handmade pump

Education for elongation

  • Massage with scrotum for 5 minutes.
  • Heating by boat for 5-10 minutes.
  • Stretching, down and on the sides-10-15 minutes.
  • Strong intensity - 10 minutes.
  • Reverse Stretch/Sadsak/A-Resting-10 minutes;
  • Jelking (dry or liquid) - 50 repetitions;
  • Packaging - 3 approaches.

Vascular technique to increase volume

  • Massage with no limit - 5 minutes.
  • Treatment - 10 minutes.
  • Stretching forward medium intensity - 5 minutes.
  • Jelking - 100 moves.
  • Bending an upright penis - 10 minutes.
  • Seated in a penis with incomplete erection - 10 minutes.
  • A pumping approach.

The number of approaches and holidays between them remains similar packaging techniques.However, the pump cylinder should be wider, which will work well to increase the volume.

During the break between the approaches, run the penis.Make it carefully to avoid painful sensations.

After the entire process, it is recommended to apply a basic moisturizing cream to the genitals - for example, a child's body lotion or use a special bruising ointment.

What is the process stops consisting of

As you could already notice, the process of using a vacuum pump includes several stages.In order to achieve the desired result, it is necessary to observe priority.We do not recommend losing the stages or change them to parts - the correct execution will be the key to safe use of the pump.

Heating a member of a hot towel

Heating

Before using the pump, it is necessary to disperse blood.To do this, the heating of a penis is performed - this can be done with a ship, a squeezing of hot towel or, by simply accepting a shower/bath.




Rap

Rap

Stretching in Jelking technique is used as preparation before using the pump.It is necessary to execute the "milking" of the penis, having previously lubricated the genitalia with lubricant.The root of the barrel is compressed by the conception of the thumb and the index.This arrest moves forward to the head.To display an average erection - about 50% requires 50 such movements.For the maximum permitted level of 80-90%-about 100 repetitions.

How to place a pump correctly

The pump cylinder should be placed in a member in a semi -elect.The penis barrel, pubis and lip of the bottle are treated with lubricant.At the same time, do not allow lubrication to the scrotum to prevent absorption in the bottle.

You should then create a sealed space with rotational movements and slowly press the pump in the pubic area.Will also allow lubrication evenly.Make about 5 such moves to achieve complete waterproofing.

Tower

The use of vacuum pump can be made in two ways - with the maximum and minimum leakage injection.

  1. The minimum accumulation of lymph nodes

    Initially, it is necessary to create an easy degree of pressure.The suction process should not be discomfort.After completing the absorption, make several movements in the bottle by touching the genital.

    From the senses you should feel a pleasant pulse and a change of pressure within 10 minutes.In the next 5 minutes, it is necessary to increase the pressure more strongly.If you feel burning or tingling at the same time, reduce the pressure at a value.

    At the end of the process, genitals must become more serious.It must be taken in the hand and perform a light shake.Then lubricate the member and perform the milking technique.

    In the second approach, increase the pressure from one unit and with the third - by two.In the end, run jelking technique.

  2. The technique of a member of a member
  3. The maximum accumulation of lymph nodes

    This technique allows the maximum to increase the volume member due to the strong rejection of the lymph nodes.This is due to the lack of massage between approaches.At the same time, the total execution time is about one hour.

    • Run pumping to the usual level of pressure for 5 minutes.
    • For a minute, adjust the pressure to a minimum level.
    • After the reintegration of the first approach.

    After an hour of such a session, take a jelking, and then shake the instrument about 50 times to get rid of stress.

The end of the session

In the end, it is necessary to gently reduce the load on the penis.For this:

  1. It is recommended to urinate after the procedure.
  2. If possible, swim or shower.
  3. Put a rubber ring in the barrel members and hold it for 40 minutes.
  4. Rings

The manipulations described above are called a member of a member in Zoinkert.It is popular with men around the world.

Beginners

A man who wants to increase a member of the procession

The above zoinzker technique is also suitable for beginners.During the execution, it is worth considering the following shades on how to use the vacuum pump:

  • If at the end of the process you notice the softness of the penis, lethargy and weakened erection, the load should be reduced.
  • To eliminate the accumulated lymphatic, you can use a gel with a bad one.
  • It is strongly recommended to warm the device before mounting a member.
  • Do not neglect the use of Gel Lord.

Initial users should understand that promoting pumping immediately to maximum indicators can be dangerous and lead to various injuries.Even with a little defined pressure, it is necessary to monitor your own senses.Maximum parameters can only be changed after a few months of regular use of the vacuum pump.

How to take care of Pomp

  1. After purchase, the new pump should be washed well with warm water and soap and treated with disinfectant.
  2. The same actions must be performed before and after each use of the vacuum pump.
  3. Wipe the device dry after cleaning and allow it to dry completely.
  4. In order for the pump to serve more, we recommend using water -based gel waste rather than fat.Do not use creams and gels containing oil refining products in your composition - for example, mineral oil.
  5. You cannot boil the pump as well as treat it with alcohol -containing agents - choose an immortal antiseptic.

Safety precautions

You need to know the rules for the safe use of the vacuum pump - otherwise, the risk of side effects increases: edema, hematomas, redness, vascular damage, etc. Also, excessive tension can cause tissue necrosis, ligament rupture and chronic dry skin.

A man has side effects after pump application

The recommendations and rules for the safe use of the pump, given by manufacturers, are as follows:

  • If painful or unpleasant sensations occur during the procedure, stop the session immediately.Learn the cause of discomfort - if injury, the classes should stop until complete healing.
  • The load must be increased smoothly by adding one unit each week.Achieving the result depends mainly on the regularity of the classes and not on the power of the impact.
  • Beginners are not recommended to take sessions to spend over 40 minutes.Experienced users should use the device for no more than one hour in a row.For a long time, the effect of the vacuum can critically disturb blood circulation.
  • Also, you should not perform more than three sinking sessions per day - the very frequent use of the device may have the opposite effect.

Contraindications for use

It is worth remembering that in some cases the use of vacuum pumps can contraindicate.These include such diseases and body condition:

  • Chronic diseases and infectious and inflammatory processes in the genital area.
  • Problems with the work of liver and kidneys.
  • Pathology in the foreskin.
  • Diseases of the cardiovascular system.
  • The risk of blood clots;
  • Diabetes.

We recommend that you start drawing only after preliminary consultations with a medical specialist in order to avoid negative health consequences.Starting, before you start using a vacuum pump, we also advise you to carefully study the use technique in photo and video instructions and get to know the reviews.

Conclusions

Increasing a member when using a vacuum pump is more than real - and we talk not only about the length of the penis but also about its diameter.This result can only be achieved by normal and long -term categories, with the status of the competent use of the device.

For beginners, we advise you to approach pumping carefully and pay close attention to the preparation for the process, trying not to overdo it.